toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Fluid Pan, A/T > < Fluid - A/T|Capacity Specifications|Page 4066
Page 2
background image

-

Remove the refill plug and add fluid.

-

Reinstall the refill plug.

4. FLUID CIRCULATION

a. Allow the engine to idle with the air conditioning OFF.
b. Move the shift lever through entire gear range to circulate fluid.

5. FLUID TEMPERATURE CHECK

NOTICE: The fluid temperature should be less than 30°C (86°F) before beginning the fluid temperature check.

a. With intelligent tester

1. Connect the intelligent tester to the DLC3.
2. Select the tester menus: OBD/MOBD, ENGINE, DATA LIST and A/T
3. Check A/T OIL TEMP.
4. Allow the engine to idle until the fluid temperature reaches 46°C (115°F).

b. Without intelligent tester (Using A/T OIL TEMP indicator)

1. Create a terminals between CG (4) and TC (B) of the DLC3 using SST (09843-18040).
2. Move the shift lever back and forth between N and D every 1.5 seconds for six seconds.
3. The D shift indicator on the combination meter comes on for two seconds. This indicates that the fluid temperature check mode has been

started.

4. The D shift indicator will come on again when the fluid temperature reaches 46°C (115°F) and will blink when it exceeds 56°C (130°F).
5. Allow the engine to idle until the fluid temperature reaches 46°C (115°F).

6. FLUID LEVEL CHECK

NOTICE: The fluid temperature must be between 46°C (115°F) and 56°C (130°F) to accurately check the fluid level.

a. Remove the overflow plug with the engine idling. 
b. Check that the fluid comes out of the overflow tube. If fluid does not come out, proceed to step 7. If fluid comes out, wait until the overflow

slows to a trickle and proceed to step 8.

7. TRANSMISSION REFILL

a. Install the overflow plug.
b. Stop the engine.
c. Remove the refill plug.
d. Add 0.4 liters (0.42 US qts, 0.35 Imp qts) of fluid.
e. Allow the engine to idle and wait for 10 seconds.
f.

Proceed to step 6.

8. COMPLETE

a. Install the overflow plug with a new gasket.
b. Stop the engine.
c. Install the refill plug with a new gasket.

Torque: 

20 Nm (205 kgf-cm, 15 ft. lbs.) for overflow plug 
39 Nm (400 kgf-cm, 29 ft. lbs.) for refill plug

Fluid Pan, A/T > < Fluid - A/T|Capacity Specifications|Page 4066