Tacoma 4WD V6-4.0L (1GR-FE) (2006)
Clutch Switch: Testing and Inspection
Clutch Start Cancel Switch
INSPECTION
1. INSPECT CLUTCH START CANCEL SWITCH ASSEMBLY
a. Using an ohmmeter, check that there is resistance between terminals 2 and 4.
Standard: 10 k ohms or higher
If the result is not as specified, replace the clutch start cancel switch.
b. Connect the positive (+) lead from the battery to terminal 3 and connect negative (-) lead to terminal 1.
c. Using an ohmmeter, check that there is resistance between terminals 2 and 4.
Standard: 10 k ohms or higher
If the result is not as specified, replace the clutch start cancel switch.
d. Check that the indicator light comes on and there is resistance between terminals 2 and 4 when the switch is pressed.
Standard: Below 1 Ohm
If the result is not as specified, replace the clutch start cancel switch.
e. Using an ohmmeter, check that there is resistance between terminals 2 and 4 when the battery lead is disconnected.
Standard: 10 k ohms or higher
If the result is not as specified, replace the clutch start cancel switch.