Tacoma 4WD V6-4.0L (1GR-FE) (2006)
d. Clamp the propeller shaft in a vise between aluminum plates.
e. Using SST, push the spider bearing out of the propeller shaft.
SST 09332-25010
HINT: Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.
f.
Clamp the removed spider bearing outer race in a vise and tap the propeller shaft to remove the spider bearing.
NOTICE: Do not tap the shaft tube.
HINT: Remove the spider bearing from the opposite side of the spider using the same procedure.
g. Separate the propeller with center bearing shaft.
h. Reinstall the 2 removed spider bearings onto the spider and clamp the spider bearings in a vise.
i.
Using SST, push the bearing out of the yoke.
SST 09332-25010
HINT: Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.
j.
Clamp the outer bearing race in a vise and tap off the yoke with a hammer.
k. Remove the spider.