Tacoma 4WD V6-4.0L (1GR-FE) (2006)
/Page-936003.png)
4. SEPARATE FRONT SPEED SENSOR
a. Remove the bolt and separate the front speed sensor.
b. Disengage the 2 clamps.
c. Remove the bolt and separate the speed sensor wire harness from the steering knuckle.
5. SEPARATE TIE ROD END SUB-ASSEMBLY
a. Remove the cotter pin and nut.
b. Using SST, separate the tie rod end from the steering knuckle.
SST 09628-62011
6. REMOVE FRONT AXLE HUB NUT
a. Using a screwdriver and a hammer, remove the front axle hub grease cap.
