Tacoma Extra Cab 2WD L4-2.4L (2RZ-FE) (1999)
Alignment: Service and Repair
NOTICE:
-
RZN140L: Tacoma Regular Cab w/2.4L DOHC (2RZ-FE) Engine
-
RZN150L: Tacoma Extra Cab w/2.4L DOHC (2RZ-FE) Engine
-
VZN150L: Tacoma Extra Cab w/3.4L DOHC (5VZ-FE) Engine
INSPECTION
1. MEASURE VEHICLE HEIGHT
Vehicle height:
Measuring points:
A: Ground clearance of spindle center.
B: Ground clearance of lower suspension arm bolt center.
C: Ground clearance of rear axle shaft center.
D: Ground clearance of leaf spring front hanger pin bolt center.
NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
If the vehicle height is not the specified value, try to adjust it by pushing down on or lifting the body.
2. INSTALL CAMBER-CASTER-KINGPIN GAUGE OR POSITION VEHICLE ON WHEEL ALIGNMENT TESTER
Follow the specific instructions of the equipment manufacturer.
3. INSPECT CAMBER, CASTER AND STEERING AXIS INCLINATION
Camber, caster and steering axis inclination: