Tacoma Extra Cab 2WD L4-2.4L (2RZ-FE) (1999)
/Page-1310007.png)
NOTICE: Remove the rack from the steering pinion housing side of the rack housing, as shown.
INSPECTION
NOTICE: When using a vise, do not overtighten it.
1. INSPECT STEERING RACK
a. Using a dial indicator, check the rack for runout and for teeth wear and damage.
Maximum runout: 0.30 mm (0.0118 inch)
b. Check the back surface for wear and damage.
2. INSPECT BEARING
a. Check the needle roller bearing for pitmarks or damage. If faulty, replace the rack housing.
b. Apply molybdenum disulfide lithium base grease to the inside of the bearing.
3. IF NECESSARY, REPLACE BUSHING
a. Using a screwdriver, loosen the 3 claws of the bushing, and remove the bushing from the rack housing.
b. Coat a new bushing with molybdenum disulfide lithium base grease.
c. Install the bushing into the rack housing, making sure to align with the 3 holes.
4. INSPECT BEARING
Check the bearing rotation condition and check for abnormal noise. If the bearing is worn or damaged, replace the steering pinion assembly.
