Tacoma Extra Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
Piston: Service and Repair
Disassembly
1. Check fit between piston and pin.
Try to move the piston back and forth on the piston pin.
If any movement is felt, replace the piston and pin as a set.
2. Remove piston rings.
(a)
Using a piston ring expander, remove the 2 compression rings.
(b) Remove the 2 side rails and oil ring expander by hand.
NOTE: Arrange the rings in the correct order only.
3. Disconnect connecting rod from piston.
(a)
Using a small screwdriver, pry out the 2 snap rings.
(b) Gradually heat the piston to 80° - 90° C (176° - 194° F).
(c)
Using a plastic-faced hammer and brass bar, lightly tap out the piston pin and remove the connecting rod.
NOTE:
