Tacoma Extra Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
Crankshaft Main Bearing Seal: Service and Repair
NOTE: There are 2 methods (A and B) to replace the oil seal which are as follows:
A. If rear oil seal retainer is removed from cylinder block.
(a)
Using a screwdriver and a hammer, tap out the oil seal.
(b) Using Special Service Tool (SST) Oil Seal & Bearing Replacer # 09223 - 15030, Handle Set # 09950 - 70010 (Handle 150 # 09951 - 07150)
or equivalents and a hammer, tap in a new oil seal until its surface is flush with the oil seal retainer edge.
(c)
Apply Multipurpose (MP) grease to the oil seal lip.
B. If rear oil seal retainer is installed to cylinder block.
(a)
Using a knife, cut off the oil seal lip.
(b) Using a screwdriver, pry out the oil seal.
CAUTION: Be careful not to damage the crankshaft. Tape the screwdriver tip.
(c)
Apply MP grease to a new oil seal lip.
(d) Using SST Oil Seal & Bearing Replacer # 09223 - 15030, Handle Set # 09950 - 70010 (Handle 150 # 09951 - 07150) or equivalents and a
hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
