Tacoma Extra Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
Intake Air Temperature Sensor: Description and Operation
Figure 1
Reference
CIRCUIT DESCRIPTION
The intake air temp. sensor is built into the air cleaner cap and senses the intake air temperature.
A thermistor built in the sensor changes the resistance value according to the intake air temperature.
The lower the intake air temperature, the greater the thermistor resistance value and the higher the intake air temperature, the lower the thermistor
resistance value (See Fig.1.).
The intake air temperature sensor is connected to the ECM (See below). The 5 V power source voltage in the ECM is applied to the intake air
temperature sensor from the terminal THA via a resistor R.
That is, the resistor R and the intake air temperature sensor are connected in series. When the resistance value of the intake air temperature sensor
changes in accordance with changes in the intake air temperature, the potential at terminal THA also changes. Based on this signal, the ECM
increases the fuel injection volume to improve driveability during cold engine operation.