Tacoma Extra Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
b. Remove the 2 steering wheel lower No. 2 covers.
c. Using a torx socket wrench, loosen the 2 torx screws.
d. Pull out the wheel pad from the steering wheel and disconnect the airbag connector.
HINT: Loosen the screw until the groove along the screw circumference catches on the screw case.
CAUTION:
^
When storing the wheel pad, keep the upper surface of the pad facing upward.
^
Never disassemble the wheel pad.
NOTICE: When removing the wheel pad, take care not to pull the airbag wire harness.
2. Remove steering wheel.
a. Disconnect the connector.
b. Remove the steering wheel set nut.
c. Place matchmarks on the steering wheel and main shaft. assembly.
d. Using SST 09950-50010 (09951-05010, 09952-05010, 09953-05020, 09954-05020), remove the wheel.
3. Remove upper and lower column covers. Remove the 5 screws.
4. Remove lower LH finish panel.
a. Remove the 2 screws and disconnect the hood lock release lever from the panel.
b. Remove the 4 panel set bolts and screw.