Tacoma Extra Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
1. Remove turn pressure tubes.
a. Using SST 09633-00020, remove the tube.
b. Remove the union seat from the rack housing.
c. Remove the union seat from the control valve housing.
2. Secure PS gear assembly in vise. Using SST 09612-00012, secure the gear assembly in a vise.
3. Remove RH and LH to rod ends and lock nuts. Place matchmarks on the tie rod end and rack end.
4. Remove RH and LH clips, rack boots and clamps.
NOTICE:
^
Be careful not to damage the boot.
^
Mark the RH and LH boots.
5. Remove RH and LH rack ends and claw washers.
a. Using a screwdriver and hammer, unstake the washer.
NOTICE: Avoid any impact to the steering rack.
