Tacoma Extra Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
5. Disconnect brake line and parking brake cable. Using SST 09751-36011, disconnect the brake line from the wheel cylinder.
Installation Hint: Torque to 15 Nm (11 ft. lbs.)
6. Remove rear axle shaft assembly.
a. Remove the 4 backing plate mounting nuts.
Installation Hint: Torque to 68 Nm (50 ft. lbs.)
b. Pull out the rear axle shaft assembly from the rear axle housing.
NOTICE: Be careful not to damage the oil seal.
7. Remove o-ring from rear axle housing.
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, bleed brake system and check ABS speed sensor signal.
Hub Bolt
HUB BOLT REPLACEMENT
1. Remove wheel and brake drum.
2. Remove hub bolt.
Using SST, 09650-17011
