Tacoma Extra Cab 2WD V6-3.4L (5VZ-FE) (1998)
Loosen/Tighten Bleeder Plug
4. Bleed brake line.
a. Slowly depress the brake pedal several times.
b. While an assistant depresses the pedal, loosen the bleeder plug until fluid starts to run out. Then tighten the bleeder plug.
c. Repeat this procedure until there are no more air bubbles in the fluid.
Torque: (bleeder plug) 11 Nm (8 ft. lbs.)
5. Repeat procedure for each wheel.
6. Bleed Load Sensing Proportioning & By-Pass Valve (LSP & BV).
LOAD SENSING PROPORTIONING AND BY-PASS VALVE (LSP & BV) ON-VEHICLE INSPECTION
HINT: Pre runner is described below.
RZN191L-TRPDKAB, RZN196LCRPDKAB, VZN195L-CRPDKAB
1. SET REAR AXLE LOAD
Rear axle load (includes vehicle weight):
2. INSTALL LSP & BV GAUGE (SST) AND BLEED AIR SST 09709-29018
3. RAISE FRONT BRAKE PRESSURE TO 7,845 kPa (8Q kgf/cm2, 1,138 psi) AND CHECK REAR BRAKE PRESSURE