Tacoma Extra Cab 2WD V6-3.4L (5VZ-FE) (1998)
1. Assemble these parts to load sensing spring:
-
Load sensing valve boot
-
Load sensing spring boot
-
4 bushings
-
2 rubber plates
-
2 collars
HINT:
-
Apply lithium soap-base glycol grease to all rubbing areas.
-
Do not mistake the valve side for the shackle side of the load sensing spring.
2. Install shackle NO.1 and NO.2
a. Install the lock nut and shackle No.1 to the shackle No.2.
b. Torque the nut.
Torque: 24 Nm (18 ft. lbs.)
3. Install load sensing spring to shackle No.1
a. Install the load sensing spring and 2 plate washer to the shackle No.1.
b. Torque the bolt and nut.
Torque: 18 Nm (13 ft. lbs.)
4. Install load sensing spring to valve body.
Install the load sensing spring to the load sensing valve with the clip.
5. Install valve bracket.
a. 2WD: Install the set plate to the valve assembly through the valve bracket and temporarily tighten the 2 valve body mounting nuts with flexible
hose bracket.
b. 4WD: Install the set plate to the valve assembly through the valve bracket and temporarily tighten the 2 valve body mounting nuts.
c. Torque the bolt and nut with the 2 plate washers.
Torque: 18 Nm (13 ft. lbs.)