Tacoma Extra Cab 2WD V6-3.4L (5VZ-FE) (1998)
NOTE: To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half of a turn.
e. Remove the generator with SST (A) and (B) from SST (C).
f.
Turn SST (B) and remove SST (A) and (B).
g. Remove the pulley nut and pulley.
6. REMOVE RECTIFIER END FRAME
a. Remove the 4 nuts.
b. Using SST, remove the rectifier end frame.
SST 09286-46011
c. Using snap ring pliers, remove the generator washer from the rectifier end frame.
7. REMOVE ROTOR FROM DRIVE END FRAME
REASSEMBLY
1. PLACE RECTIFIER END FRAME ON PULLEY
2. INSTALL ROTOR TO DRIVE END FRAME