Tacoma Extra Cab 2WD V6-3.4L (5VZ-FE) (1998)
Using a plastic hammer, tap in 2 new pins to the front housing.
NOTICE: Be careful not to damage the pins.
3. Install vane pump shaft.
4. Install cam ring.
Install the ring with the inscribed mark facing outward.
HINT: Align the holes of the cam ring with the straight pins.
5. Install vane pump rotor.
a. Install the rotor with the inscribed mark facing outward.
b. Install a new snap ring to the vane pump shaft.
6. Install vane plates.
Install the 10 plates with the round end facing outward.
7. Install gasket.
Install a new gasket on the front housing.
NOTICE: Be careful the direction of the gasket.
8. Install side plate.