Tacoma Extra Cab 2WD V6-3.4L (5VZ-FE) (1998)
/Page-1472004.png)
1. SECURE MANUAL STEERING GEAR IN VISE.
Using Special Service Tool (SST) 09612-00012 or equivalent, and 2 bolts, secure the gear assembly in a vise, as shown in the illustration.
Reference:
Bolt: 90105-10017
Nut: 90170-10198
HINT: Use 2 of the same type of SST.
2. REMOVE RH AND LH TIE ROD ENDS AND LOCK NUTS.
Place matchmarks on the tie rod end and rack end.
3. REMOVE RH AND LH CLIPS, RACK BOOTS AND CLAMPS.
Using a screwdriver, loosen the clamp.
NOTICE: Be careful not to damage the boot. Mark the RH and LH boots.
