Tacoma Extra Cab 4WD L4-2693cc 2.7L DOHC MFI (1997)
Wheel Speed Sensor: Service and Repair
Rear
Rear Speed Sensor Components
REMOVAL
1. Remove speed sensor.
Disconnect Speed Sensor Connector
(a) Disconnect the speed sensor connector, and pull out the sensor wire harness with grommet.
(b) Remove the 5 resin clips, 2 clamp set bolts and 2 nuts holding the sensor wire harness from the side rail, fuel tank and axle housing.
Remove Clamp Bolts
(c) Remove the 2 mountings bolt and speed sensor.
Torque: 8.0 Nm (71 inch lbs.)
INSTALLATION
Installation is in the reverse order of removal.
After installation, check speed sensor signal.
CAUTION: Make sure that:
-
There are no foreign objects on the sensor or the part of the axle end to which the sensor is to be installed.
-
The sensor is installed flat against the knuckle when you tighten the bolt.
-
When installing the resin clips, use new ones.
