Tacoma Extra Cab 4WD L4-2693cc 2.7L DOHC MFI (1997)
a. Install a new washer, and temporarily tighten the rack end.
HINT: Align the claws of the washer with the steering rack grooves.
b. Using a spanner to hold the steering rack steady, and using SST 09922-10010, torque the rack end.
Torque to 76 Nm (56 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and hammer, stake the washer.
NOTICE: Avoid any impact to the rack.
14. Install RH and LH rack boots, clamps and clips.
15. Install RH and LH tie rod ends and lock nuts.
16. Install 2 turn pressure tubes.
a. Install a new union seat to the rack housing.
b. Install a new union seat to the control valve housing.
c. Using SST 09633-00020, install the tube.
Torque to 20 Nm (15 ft. lbs.)
HINT:
^
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
^
This torque value is effective in case that SST is parallel to a torque wrench.
Inspection and Replacement
