Tacoma Extra Cab 4WD L4-2693cc 2.7L DOHC MFI (1997)
05 2.05 mm (0.0807 inch)
06 2.06 mm (0.0811 inch)
07 2.07 mm (0.0815 inch)
08 2.08 mm (0.0819 inch)
09 2.09 mm (0.0823 inch)
10 2.10 mm (0.0827 inch)
11 2.11 mm (0.0831 inch)
12 2.12 mm (0.0835 inch)
13 2.13 mm (0.0839 inch)
14 2.14 mm (0.0843 inch)
15 2.15 mm (0.0846 inch)
16 2.16 mm (0.0850 inch)
17 2.17 mm (0.0854 inch)
18 2.18 mm (0.0858 inch)
19 2.19 mm (0.0862 inch)
20 2.20 mm (0.0866 inch)
21 2.21 mm (0.0870 inch)
22 2.22 mm (0.0874 inch)
23 2.23 mm (0.0878 inch)
24 2.24 mm (0.0882 inch)
25 2.25 mm (0.0886 inch)
26 2.26 mm (0.0890 inch)
27 2.27 mm (0.0894 inch)
28 2.28 mm (0.0898 inch)
14. Remove companion flange.
15. Remove front bearing.
16. Install new bearing spacer, 2 washers and front bearing.
a. install a new bearing spacer and 2 washers, and place the front bearing.
b. Using SST 09950-30010 (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03050) and the companion flange, install the front
bearing then remove the companion flange.
17. Install new oil seal.
a. Coat a new oil seal lip with MP grease.
b. Using SST 09649-17010, 09316-12010, install the oil seal until its surface is flush with the differential carrier end.
HINT: Connect SST with vinyl tape.
18. Install companion flange.
a. Place the companion flange.
b. Coat the threads of a new nut with hypoid gear oil.
