Tacoma Extra Cab Limited 4WD V6-3.4L (5VZ-FE) (2000)
2. REMOVE LSP & BV ASSEMBLY
a. Using SST, disconnect the brake lines from the valve body.
SST 09023-00100
b. Remove the clip from the flexible hose bracket.
c. 2WD: Remove the 3 valve bracket mounting bolts and spacer, and remove the LSP & BV assembly.
d. 4WD and Pre runner: Remove the 3 valve bracket mounting bolts, spacer and flexible hose bracket mounting bolt, and remove the LSP & BV
assembly and flexible hose bracket.
INSTALLATION
1. INSTALL LSP & BV ASSEMBLY TO FRAME
a. 2WD: Install the 3 valve bracket mounting bolts and spacer with the LSP & BV assembly.
b. 4WD and Pre runner: Install the 3 valve bracket mounting bolts, spacer and flexible hose bracket mounting bolt with the LSP & BV assembly
and flexible hose bracket.
Torque: 29 Nm (300 kgf-cm, 22 ft. lbs.)
2. CONNECT BRAKE LINE
Using SST, connect the brake lines.
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
SST 09023-00100
3. CONNECT SHACKLE NO. 2 TO SHACKLE BRACKET
a. Install the shackle No. 2 to the shackle No. 1 with the 2 nuts.
b. Set dimension A.
Initial Set:
c. Tighten the lock nut.
Torque: 24 Nm (250 kgf-cm, 18 ft. lbs.)
d. Install the shackle No. 2 with the 2 cushions and collar to the shackle bracket.
e. Install the nut to fix the cushion retainer.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
4. SET REAR AXLE LOAD
5. SET VALVE BODY
a. When pulling down the load sensing spring, confirm that the valve piston moves down smoothly.