Tacoma Extra Cab Limited 4WD V6-3.4L (5VZ-FE) (2000)
/Page-927002.png)
2. DISCONNECT SPRING FROM VALVE
Using pliers, remove the clip, and remove the spring from the valve.
3. REMOVE SHACKLES NO.1 AND NO.2
a. Remove the nut and bolt, and remove the load sensing spring and 2 plate washers.
b. Loosen the 2 nuts, and remove the shackle No. 1 from the shackle No. 2.
4. DISASSEMBLE LOAD SENSING SPRING
a. Remove the 4 bushings, 2 collars and 2 rubber plats.
b. Remove the load sensing valve boot and load sensing spring boot.
INSPECTION
INSPECT VALVE PISTON PIN AND LOAD SENSING CONTACT SURFACE FOR WEAR
Wear limit: 0.7 mm (0.028 inch)
REASSEMBLY
