Tacoma Extra Cab Limited 4WD V6-3.4L (5VZ-FE) (2000)
NOTICE: Be careful the direction of the gasket.
8. INSTALL SIDE PLATE
Align the holes of the plate and 2 straight pins.
9. INSTALL WAVE WASHER
Install the washer so that its protrusions fit into the slots in the side plate.
10. INSTALL REAR HOUSING
a. Coat 2 new O-rings with power steering fluid and install them to the housing.
b. Torque the 2 bolts.
Torque: 24 Nm (240 kgf-cm, 17 ft. lbs.)
11. INSTALL SPRING, FLOW CONTROL VALVE AND PRESSURE PORT UNION
a. Install the valve facing the correct direction.
b. Coat a new O-ring with power steering fluid and install it to the union.
c. Torque the union.
Torque: 83 Nm (850 kgf-cm, 62 ft. lbs.)
12. INSTALL BRACKET
Torque the 2 bolts.
Torque: 43 Nm (440 kgf-cm, 32 ft. lbs.)
13. INSTALL OIL RESERVOIR
a. Coat a new O-ring with power steering fluid and install it to the oil reservoir.
b. Install the oil reservoir with the 3 bolts.
Torque:
Front side bolt: 13 Nm (130 kgf-cm, 9 ft. lbs.)
Rear side bolts: 24 Nm (240 kgf-cm, 17 ft. lbs.)
14. INSTALL VANE PUMP PULLEY
Using SST to stop the pulley rotating, torque the nut.
SST 09960-10010 (09962-01000, 09963-01000)
Torque: 43 Nm (440 kgf-cm, 32 ft. lbs.)
15. MEASURE PS VANE PUMP ROTATING TORQUE