Tacoma Extra Cab Limited 4WD V6-3.4L (5VZ-FE) (2000)
a. Position SST on the backing plate with the 4 nuts.
SST 09521-25011
b. Using a press, remove the rear axle shaft and bearing retainer from the backing plate.
c. Remove the SST.
4. INSPECT AXLE SHAFT
Using a dial indicator, measure the runout of the shaft and flange.
Maximum shaft runout: 2.0 mm (0.079 inch)
Maximum flange runout: 0.1 mm (0.004 inch)
If the rear axle shaft or flange are damaged or worn, or if runout is greater than the maximum, replace the rear axle shaft.
5. REMOVE OUTER OIL SEAL
Using SST, remove the oil seal.
SST 09308-00010
6. REPLACE REAR AXLE BEARING