Tacoma PreRunner L4-2.7L (2TR-FE) (2005)
/Page-798005.png)
d. Remove the 4 nuts and pull out the brake master cylinder.
e. Remove the brake booster gasket.
12. REMOVE BRAKE ACTUATOR BRACKET NO.1
a. Using a hexagon wrench (5 mm), remove the screw and brake actuator bracket No.1.
b. Using a screwdriver, remove the fluid level warning switch connector.
13. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
a. Remove the screw from the master cylinder reservoir.
b. Using a pin punch and hammer, remove the pin from the master cylinder reservoir.