Tacoma PreRunner L4-2.7L (2TR-FE) (2005)
f.
Install the 2 new plugs.
34. INSTALL BRAKE ACTUATOR TUBE NO.1
a. Using SST, install the brake actuator tube No.1.
SST 09023-00101
Torque:
15.2 Nm (155 kgf-cm, 11 ft. lbs.) for use without SST
14 Nm (143 kgf-cm, 10 ft. lbs.) for use with SST
HINT:
-
Use a torque wrench with a fulcrum length of 250 mm (9 84 inch)
-
This torque value is effective when SST is parallel to a torque wrench.
35. INSTALL BRAKE ACTUATOR HOSE
a. Using needle-nose pliers, install the brake actuator hose and 2 clips.
36. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
a. Install the cap.
b. Apply lithium soap base glycol grease to the 3 new grommets.
c. Install the 3 grommets to the master cylinder body.
NOTICE: Be careful of the size of each grommets.
d. Install the master cylinder reservoir.
e. Using a pin punch and hammer, install a new pin onto the master cylinder reservoir.