Tacoma PreRunner L4-2.7L (2TR-FE) (2005)
Wheel Speed Sensor: Service and Repair
Rear
SPEED SENSOR REAR LH
REPLACEMENT
HINT: The replacement procedures for the RH side are the same as those for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE SPEED SENSOR REAR LH
a. Disconnect the speed sensor connector.
b. Remove the nut and speed sensor rear.
NOTICE:
-
Do not attach any foreign matter to the sensor tip.
-
Ensure that no foreign matter enters the sensor installation hole.
3. INSTALL SPEED SENSOR REAR LH
a. Install the rear speed sensor with the nut.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE: Make sure that the sensor tip is clean.
b. Connect the speed sensor connector.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 inch lbs.)
5. CHECK ABS SENSOR SIGNAL