Tacoma PreRunner L4-2.7L (2TR-FE) (2005)
2. DISCONNECT THE NEGATIVE BATTERY CABLE
3. LOCATE THE BENCH SEAT FLOOR WIRE HARNESS
(c) Slide the bench seat to the rearmost position.
(d) Locate the floor wire harness and connector under the seat on the driver's side, closest to the front edge of the seat cushion.
4. INSTALL THE WIRE SEAT JUMPER
NOTE:
DO NOT install the wire seat jumper on a vehicle which is NOT on the VIN list!
(a) Push the lock tab on the connector and pull to remove the female portion of the connector.
(b) Before installing the wire seat jumper to the vehicle, attach the Warning Label (shown in the illustration) onto the corrugated tubing, next to the
Part Number Label.
NOTE:
^
Attach the Warning Label in a similar manner to the Part Number Label, making sure not cover the information printed on it.
^
DO NOT remove the Part Number Label or cover it with the Warning Label.
^
A small supply of labels were sent with the Service Manager Package. Additional labels can be ordered from the Material Distribution Center
(p/n 00410-92017).