Tacoma PreRunner L4-2.7L (2TR-FE) (2005)
Clutch Switch: Service and Repair
Clutch Start Switch Assy
Inspection
CLUTCH START SWITCH ASSEMBLY
ON-VEHICLE INSPECTION
1. CHECK CLUTCH START SYSTEM
a. Check that the engine does not start when the clutch pedal is released.
b. Check that the engine starts when the clutch pedal is fully depressed.
If necessary, replace the clutch start switch assembly.
Replacement
CLUTCH START SWITCH ASSEMBLY
REPLACEMENT
1. REMOVE CLUTCH START SWITCH ASSEMBLY
a. Disconnect the clutch start switch assembly connector.
b. Remove the nut and clutch start switch assembly from the clutch pedal support.
2. INSTALL CLUTCH START SWITCH ASSEMBLY
a. Install the clutch start switch assembly with the nut.
Torque: 16 Nm (160 kgf-cm, 12 ft. lbs.)
b. Connect the clutch start switch assembly connector.
3. INSPECT CLUTCH START SWITCH ASSEMBLY