Tacoma PreRunner L4-2.7L (3RZ-FE) (2004)
SST 09630-00014 (09631-00142), 09950-60010 (09951-00180, 09951-00190)
2. REMOVE FLUID LEVEL WARNING SWITCH CONNECTOR CLAMP
a. Disconnect the connector.
b. Remove the bolt and clamp.
3. REMOVE RESERVOIR AND GROMMETS
a. Remove the reservoir cap.
b. Remove the 3 set screws and pull out the reservoir.
Torque: 1.7 Nm (17.5 kgf-cm, 15.2 inch lbs.)
c. Remove the 3 grommets.
4. REMOVE CLEVIS AND CYLINDER BOOT
a. Loosen the lock nut, then remove the clevis and lock nut.
Torque: 25 Nm (260 kgf-cm, 19 ft. lbs.)
b. Remove the cylinder boot.
5. REMOVE BRAKE ACTUATOR TUBE NO. 1
Using SST, remove the brake actuator tube No. 1.
SST 09023-00100
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
6. REMOVE BOOSTER PUMP AND ASSEMBLY
a. Remove the actuator hose.
b. Remove the 4 screws and wire harness from the booster and pump.
c. Remove the 2 bolts and accumulator bracket.
d. Remove the 2 bolts and booster pump motor assembly.
e. Remove the bolt and No. 1 pump bracket.
f.
Remove the 2 washers, 2 cushions, 2 collars and sleeve.
g. Remove the 2 bolts and No. 2 pump bracket.
h. Remove the cushion from No. 2 pump bracket.
7. REMOVE MASTER CYLINDER PRESSURE SENSOR
Using a 30 mm deeper socket wrench, remove the oil pressure sensor.
Torque: 75 Nm (765 kgf-cm, 55 ft. lbs.)
NOTICE: If replacing the master cylinder pressure sensor, since the sensor is non-reusable, use a sensor of the supply part No. shown.
PART NO: 89637-30050