Tacoma PreRunner L4-2.7L (3RZ-FE) (2004)
e. Retract the whole belt, then pull out the belt until 200 mm (7.87 in.) of belt remains retracted.
f.
Tilt the retractor slowly.
g. Make sure that the belt can be pulled out at a tilt of 15 degrees or less, and cannot be pulled out at over 45 degrees of tilt.
If a problem is found, replace the assembly.
4. Manual type:
TESTING
a. Adjust the belt to the proper length.
b. Apply a firm load to the belt.
c. Make sure that the belt does not extend.