Tacoma PreRunner L4-2.7L (3RZ-FE) (2004)
HINT: When replacing the propeller shaft, install new parts facing, as shown in the illustration.
1. 3-joint type: INSTALL CENTER SUPPORT BEARING ON INTERMEDIATE SHAFT
Install the center support bearing and spacer.
HINT: Install the center support bearing with the cutout toward the rear.
2. 3-joint type: INSTALL FLANGE ON INTERMEDIATE SHAFT
a. Coat the splines of the intermediate shaft with MP grease.
b. Place the flange on the shaft and align the matchmarks.
HINT: If replacing either the center flange or intermediate shaft, reassemble them so that the front flange yoke of the intermediate shaft and
the rear flange yoke of the propeller shaft are facing in the same direction.