Tacoma PreRunner V6-4.0L (1GR-FE) (2006)
h. Using SST remove the oil filter.
SST 09228-07501
i.
Remove the drain hose and install the drain pipe cap.
j.
Clean the oil catch plate.
INSTALLATION
1. INSTALL OIL FILTER SUB-ASSEMBLY
a. Clean the oil filter contact surface on the oil filter bracket.
b. Apply clean engine oil to the rubber gasket of a new oil filter.
c. Tighten the oil filter by hand until the rubber gasket comes into contact with the seat of the filter bracket.
d. Using SST tighten it an additional 3/4 turn to set the filter.
SST 09228-07501
Torque: 18 Nm (184 kgf-cm, 13 ft. lbs.)
2. ADD ENGINE OIL
a. Fill with fresh engine oil.
Capacity: 2WD
Capacity: Pre Runner & 4WD