Tacoma PreRunner V6-4.0L (1GR-FE) (2006)
Accelerator Pedal: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE ACCELERATOR PEDAL ROD ASSEMBLY
a. Disconnect the accelerator position sensor connector.
b. Remove the 2 bolts, then remove the accelerator pedal.
INSTALLATION
1. INSTALL ACCELERATOR PEDAL ROD ASSEMBLY
NOTE:
-
Avoid any physical impact to the accelerator pedal assembly.
-
Do not disassemble the accelerator pedal assembly.
a. Install the accelerator pedal with the 2 bolts.
Torque: 5 N.m (51 kgf.cm, 44 in.lbf)
b. Connect the accelerator position sensor connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)