Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
b. Inspect position sensor resistance.
(1) Place the servomotor arm in the "WARM" position and measure the resistance between terminals 2 and 3.
Please refer to the chart for specification.
(2) Place the servomotor arm in the "COOL" position and measure the resistance between terminals 2 and 3.
Please refer to the chart for specification.
If resistance is not as specified, replace the servomotor.
3. INSTALL AIR MIX SERVOMOTOR
a. Install the 3 screws and servomotor.
b. Connect the servomotor connector.