Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
Refrigerant Pressure Sensor / Switch: Service and Repair
REMOVAL
1. REMOVE EVAPORATOR
2. REMOVE PRESSURE SWITCH FROM LIQUID TUBE
a. Disconnect the pressure switch connector.
b. Remove the pressure switch and O-ring.
Torque: 10 N.m (100 kgf.cm, 7 ft.lbf)
HINT:
-
Lock the switch mounted on the tube with an open end wrench, being careful not to deform the tube and remove the switch.
-
At the time of installation, please refer to the following item.
Lubricate a new O-ring with the compressor oil and install the switch.
INSTALLATION
Installation is in the reverse order of removal.