Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
/Page-1304001.png)
Oil Pressure Sender: Testing and Inspection
INSPECT LOW OIL PRESSURE SWITCH
a. Disconnect the connector from the switch.
b. Check that continuity exists between terminal and ground with the engine stopped.
c. Check that no continuity exists between terminal and ground with the engine running.
HINT: Oil pressure should be over 49 kPa (0.5 kgf/sq.cm, 7.1 psi).
If operation is not as specified, replace the switch.
