Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
Seals and Gaskets: Service and Repair
ON-VEHICLE REPAIR
1. REMOVE DRAIN PLUG AND DRAIN ATF
2. REMOVE PROPELLER SHAFT
3. REMOVE TRANSMISSION OUTPUT FLANGE
a. Use a chisel and hammer, loosen the staked part of the nut.
HINT: Shift the shift lever to the P position.
b. Remove the nut.
c. Tap the output flange with a plastic hammer to remove it an washers.
d. Using in a screwdriver, remove the oil seal from the output flange.
4. ROVE EXTENSION HOUSING REAR OIL SEAL
Using SST, remove the oil seal.
SST 09308-00010
5. INSTALL EXTENSION HOUSING REAR OIL SEAL
a. Coat the lip of a new oil seal with MP grease.
b. Using SST and a plastic hammer, drive in the oil seal with the facing downward.
SST 09309-37010
Oil seal depth from flat end: 0 - 0.3 mm (0 - 0.012 inch)
6. INSTALL TRANSMISSION OUTPUT FLANGE