Tacoma PreRunner Extra Cab 2WD L4-2.7L (3RZ-FE) (1998)
3. Mark the alignment value measured when the vehicle was non-loaded on the adjustment chart.
Example:
Camber: -0° 10' (-0.17°)
Caster: 1°40' (1.67°)
4. As shown in the chart, read the distance from the measured value to the standard value, and adjust the front and/or rear adjusting cams
accordingly.
Example:
Front cam: - (Shorter) 2.8
Rear cam: - (Shorter) 2.8
d. Torque the front and/or rear adjusting cam nuts.
Torque: 130 Nm (1,325 kgf-cm, 96 ft. lbs.)
Measuring Point Reference
5. INSPECT TOE-IN
Toe-in:
If the toe-in is not within the specified value, adjust the rack ends.
6. ADJUST TOE-IN AND WHEEL ANGLE
HINT: First, check or adjust the lengths of the rack ends, then adjust the toe-in.
Rack end length difference: 1.5 mm (0.059 inch) or less
a. Remove the 2 clips.