Tacoma PreRunner Extra Cab 2WD L4-2.7L (3RZ-FE) (1998)
/Page-1340010.png)
b. Using SST 09631-10021, torque the rack guide spring cap.
Torque to 25 Nm (18 ft. lbs.)
c. Using SST 09612-24014 (09616-10010), 09631-10021, while gradually loosening the rack guide spring cap, measure,and adjust the preload.
Preload (turning): 1.3 Nm (11.3 inch lbs.) or less.
9. INSTALL RACK GUIDE SPRING CAP LOCK NUT.
a. Apply sealant THREE BOND 1344, LOCTITE 242 or equivalent to 2 or 3 threads of the nut.
b. Using SST to stop the rack guide spring cap rotating, and using SST 09631-10021, 09922-10010, torque the nut.
Torque to 50 Nm (37 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Recheck the total preload.
Preload (turning): 1.3 Nm (11.3 inch lbs.) or less
d. Remove the RH and LH rack ends.
10. INSTALL RACK HOUSING NO. 2 BRACKET AND GROMMET.
a. Align the matchmarks on the bracket and rack housing.
b. Torque the bolt.
Torque to 61 Nm (45 ft. lbs.)
11. INSTALL RH AND LH CLAW WASHERS AND RACK ENDS.
a. Install a new washer, and temporarily tighten the rack end.
HINT: Align the claws of the washer with the steering rack grooves.
b. Using a spanner to hold the steering rack steady, and using SST 09922-10010, torque the rack end.
Torque to 61 Nm (45 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
