Tacoma PreRunner Reg Cab 2WD L4-2.7L (3RZ-FE) (1999)
Loosen/Tighten Bleeder Plug
3. CONNECT VINYL TUBE TO BRAKE CALIPER OR WHEEL CYLINDER BLEEDER PLUG
Insert the other end of the tube in a half-full container of brake fluid.
HINT: Begin air bleeding from the wheel cylinder with the longest hydraulic line.
4. BLEED BRAKE LINE
a. Slowly depress the brake pedal several times.
b. While an assistant depresses the pedal, loosen the bleeder plug until fluid starts to run out. Then tighten the bleeder plug.
c. Repeat this procedure until there are no more air bubbles in the fluid.
Torque: (bleeder plug) 11 Nm (110 kgf-cm, 8 ft. lbs.)
5. REPEAT PROCEDURE FOR EACH WHEEL.
LOAD SENSING PROPORTIONING AND BY-PASS VALVE (LSP & BV) ON-VEHICLE INSPECTION
HINT: Pre runner is described below.
RZN191L-TRPDKAB, RZN196LCRPDKAB, VZN195L-CRPDKAB
1. SET REAR AXLE LOAD
Rear axle load (includes vehicle weight):
2. INSTALL LSP & BV GAUGE (SST) AND BLEED AIR SST 09709-29018