Tacoma PreRunner Reg Cab 2WD L4-2.7L (3RZ-FE) (1999)
Data Link Connector: Testing and Inspection
DLC3 INSPECTION
Check the DLC3.
The vehicle's ECM uses the ISO 9141-2 communication protocol. The terminal arrangement of DLC3 complies with SAE J1962 and matches the ISO
9141-2 format.
HINT: If your display shows "UNABLE TO CONNECT TO VEHICLE" when you have connected the cable of the OBD II scan tool or TOYOTA
hand-held tester to DLC3, turned the ignition switch ON and operated the scan tool, there is a problem on the vehicle side or tool side.
-
If communication is normal when the tool is connected to another vehicle, inspect DLC3 on the original vehicle.
-
If communication is still not possible when the tool is connected to another vehicle, the problem is probably in the tool itself.