Tacoma PreRunner Reg Cab 2WD L4-2.7L (3RZ-FE) (1999)
/Page-1439013.png)
d. Install the rings to the control valve assembly, and settle them down with your fingers.
e. Carefully slide the tapered end of SST over the rings until the ring fits to the steering rack.
SST 09631-20081
NOTICE: Be careful not to damage the rings.
10. IF NECESSARY, REPLACE UNION SEATS
a. Using a screw extractor, remove the 2 seats from the control valve housing.
b. Using a plastic hammer and sliding handle, lightly tap in 2 new seats.
NOTICE: Before installing the union seat, remove dust sticking to the control valve housing.
REASSEMBLY
NOTICE: When using a vise, do not overtighten it.
1. COAT WITH POWER STEERING FLUID OR MOLYBDENUM DISULFIDE LITHIUM BASE GREASE
2. INSTALL SPACER AND OIL SEAL
a. Coat a new oil seal lip with power steering fluid.
b. Using SST, press in the oil seal and spacer.
SST 09951-60010 (09951-00330, 09951-00490, 09952-06010), 09951-70010 (09951-07360)
