Tacoma PreRunner Reg Cab 2WD L4-2.7L (3RZ-FE) (1999)
1. Drill off the head of the rivet and drive it out.
2. Install a new rivet into the holes of the spring leaf and clip. Then rivet with a press
d. Install spring center bolt.
1. Align the leaf holes and secure the leaves with vise.
2. Install the spring center bolt.
Torque: 44 Nm (450 kgf-cm, 33 ft. lbs.)
e. Bend the spring clip.
1. Using a hammer, bend the spring clip into the position.
3. 2WD (Except pre runner):
REPLACE SPRING BUMPER
a. Remove the 2 bolts and spring bumper.
b. Install the 2 bolts and spring bumper.
Torque: 29 Nm (300 kgf-cm, 22 ft. lbs.)
INSTALLATION
Installation is in the reverse order of removal.