Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
Cruise Control Switch: Testing and Inspection
Input Signal Check
DENSO Made
HINT:
1. For check No.1 - No.2:
Turn the ignition switch ON.
2. For check No.3:
-
Turn ignition switch ON.
-
Shift to D position.
3. For check No.4:
-
Jack up the vehicle.
-
Start the engine.
-
Shift to D position.
a. Press the control switch to SET/COAST or RES/ACC position and hold it down or hold it up "1".
b. Push the main switch ON "2".
c. Check that the CRUISE MAIN indicator light blinks twice or 3 times repeatedly after 3 seconds.
d. Turn the SET/COAST or RES/ACC switch OFF.
e. Operate each switch as listed in the table.