Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
2. REMOVE FRONT AIRBAG SENSOR RH
a. Disconnect the front airbag sensor connector.
NOTE: Disconnect the connector with the front airbag sensor installed.
b. Remove the 2 nuts and front airbag sensor RH.
3. REMOVE FRONT AIRBAG SENSOR LH
a. Disconnect the front airbag sensor connector.
NOTE: Disconnect the connector with the front airbag sensor installed.
b. Remove the 2 bolts and front airbag sensor LH.
INSTALLATION
1. INSTALL FRONT AIRBAG SENSOR LH AND RH
a. Install the front airbag sensor with the 2 bolts and 2 nuts with the arrows on the sensors facing toward the front of the vehicle.
Torque: 20 Nm (205 kg.cm, 15 ft.lb)
NOTE:
-
Connection of the connector is done after the sensor has been installed.
-
Make sure the sensor is installed with the specified torque.