Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
/Page-1054001.png)
Repairs and Inspections Required After a Collision: Service and Repair
Seat Belt System
REPAIRS AND INSPECTIONS REQUIRED AFTER A COLLISION
SEAT BELT SYSTEMS
CAUTION: Replace the seat belt assembly (outer belt, inner belt, bolts, nuts or sill-bar) if it has been used in a severe impact. The entire assembly
should be replaced even if damage is not obvious.
1. PRETENSIONER IS NOT ACTIVATED
a. Perform a diagnostic system check.
b. Perform a visual check which includes the following items with the front seat outer belt removed from the vehicle.
-
Check for cuts and cracks in, or marked discoloration on the quarter trim panel.
-
Check for cuts and cracks in wire harness, and for chipping in connectors.
-
Check for deformation of the center floor No.3 crossmember.
NOTE: For removal and installation of the front seat outer belt.
2. PRETENSIONER IS ACTIVATED
a. Perform a diagnostic system check.
b. Perform a visual check which includes the following items with the front seat outer belt removed from the vehicle.
-
Check for deformation of the center floor No.3 crossmember.
-
Check for damage on the connector and wire harness.
* Refer to SRS Warning Light Check, and How to Display and Read Diagnostic Trouble Codes.
