Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
c. Remove the 3 bolts and back panel trim.
d. Using a screwdriver, remove the back panel lower garnish.
HINT: Tape the screwdriver tip before use.
e. Remove the 4 bolts and rear seat cushions.
f.
Remove the front and rear seat outer belt shoulder anchors.
Using a screwdriver, open the covers, then unfasten the bolts and remove the front and rear seat outer belt shoulder anchors.
HINT: Tape the screwdriver tip before use.
g. Remove the lock handle.
1. Using a screwdriver, remove the cover.
HINT: Tape the screwdriver tip before use.
2. Remove the 2 screws and lock handle.
h. Remove the quarter trim.
1. Remove the 2 bolts and front and rear seat outer belt floor anchors.
2. Remove the screw and coat hook.
3. Using a screwdriver, remove the quarter trim.
NOTE: Paying enough attention remove the clip on the quarter trim shown in the illustration. Otherwise, the quarter trim or the front
pillar garnish might be broken.
HINT: Tape the screwdriver tip before use.