Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
/Page-877006.png)
c. Install the 5 screws until there is a clearance of approx. 1 mm (0.04 in.) between the brush holder and connector.
Torque: 1.96 Nm (20 kg.cm, 17.4 in.lb)
7. INSTALL REAR END COVER
a. Install the end cover with the 3 nuts.
Torque: 4.5 Nm (46 kg.cm, 40 in.lb)
b. Install the terminal insulator with the nut.
Torque: 4.1 Nm (42 kg.cm, 36 in.lb)
8. CHECK THAT ROTOR ROTATES SMOOTHLY
REPLACEMENT
1. REPLACE BRUSHES
a. Unsolder and remove the brush and spring.
b. Run the wire of a new brush through the spring and the hole in the brush holder, and insert the spring and brush into the brush holder.
