Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
2. Position new No.1 gasket on plate.
3. Place lower valve body with plate and gaskets on rear upper valve body. Hold the lower valve body, plate and gaskets securely so they do not
separate. Align each bolt hole in the valve bodies with the gaskets and plate.
4. Install and finger tighten bolts in lower valve body to secure rear upper valve body, as follows:
a. Install and finger tighten the bolt.
NOTE: Bolt length (mm, in.) is indicated in the illustration.
b. Hold the rear upper valve body and lower valve body, turn over the assembly.
c. Install and finger tighten the five bolts.
NOTE: Bolt length (mm, in.) is indicated in the illustration.